Tdm Over IP (Ipce Circuit Simulator)
IPCE Circuit Simulator is TDM OVER IP Device. As long as the IP
address of two terminals can recognize each other, then this device
can transmit E1 signal via IP network readezvous point and can
achieve join monolithically with existing TDM Terminal, Such as
PSTN connection, ATM, Frame relay, ISDN, concentrated user exchange
and so on. Provides various operation of TDM directly and don't
need change any Terminal. Product Feature 1. Transmit frame or
unframed 1E1-8E1 signal via IP net, Filly compatible with G. 703 2.
High transmission rate and low transmission delay 3. Clock revert
stably, small dithering and excursion 4. Possess QoS guarantee,
supports transmit with date at the same time, assure E1 date prior
transmission 5. Convenient to use, don't need complex setting 6.
Transmission package look for address base on IP address and can be
configured and revisable 7. Transmission package base on IP date
package, shield specific transmission medium, not only can be used
in Ethernet / Token-ring or other wired network, but also can be
used to increase point to point TDM of wireless LAN. Even can be
used in network which mix with wired and wireless 8. Developed a
echo counteract device to E1 that it can cancel echo of outside
128ms for some IP transmission network delay is too large and echo
problem in voice communication Setting and Diagnosis 9. Ipce
provides menu mode setting service, convenient to use 10. Ipce
provides long-distance login connector to set long-distance device
via telnet 11. Ipce supports dynamic upgrade, when download new
software edition, the old software will be save in backup section.
So, if new software be damaged, system can still use old software
12. System provides various alarm: LOS, AIS, LOF and so on 13. Ipce
provides local startup auto-inspection, and the inspection result
can be observe via super terminal 14. Ipce provides statistic of
network affair: date package lose, date package delay, date package
wobble and so on Technologies reference 15. LAN interface: Port
standard: IEEE802. 3, IEEE802. 3u Port type: RJ45 Port mode:
Auto-adapt to 10 / 100M Protocol: CSMA / CD 16. E1 interface: Line
code: HDB3 Bit rate: 2048KBIT / S + -50ppm Frame structure: ITU-G.
704, ITU-G. 706 Impedance: 75ohm (unbalance) or 120ohm (balance)
optional 17. Power Voltage: 220V AC or-48V DC Power consumption:
<10W (equip fully) 18. Working environment: Operating
temperature: 0~45 degree Environment humidity: 90% (non-condensing)
Dimension: 482mmX44mmX209mm
